Constructia

Here are some shots of the workings of the models. I know some of this has been posted already but I never all of the showed the set-up, the stages. Here you go:

The Hammer. This wasn't too difficult to make, it wasn't mainly the fact that some of the vertexs were acting odd, like duplicating or no reason at all from some simple changes. I have a weakness for making the shapes more circular in polygons, in which I need to know a different technique for this

The Grab Machine. This was just annoying. While It took ages to make this compared to the others I learnt more modelling from this than the other models pre-produced. Im happy with it and can't wait for it to be textured.

The Airhockey Table. This causes even more problems than the Grab Machine. The fact that I "squished out" the main table at the start caused extruding and movement problems which if this was animated it would be causing a lot of troubles. I'm happy to know that is not the case and I know what to do in the future.

IN THE WORKS

The Funfair Minigame Stools.

Not much to show here since I'm working on this right now, but it uses the basis of how I make buildings. It should look like the "Arcadia" once done to blend into the style of the funfair.

The Money Dispencer.

Not too much in the ways of troubles, shows what I can create with a lot of extruding and movement. This was meant for texturing though as it can be hard to tell what it is without is other than "a stand".

The Arcade Machine.

This is my most proudest achievement and the main factor of the "Arcadia". It was fast, effective and hardly any difficulties. I wish other models could have done this... oh well.

Well that's pretty much it for now. In future these posts are going to be in my blog as they seem more persoanl to me and I can communicate with the group with plans instead. Oh and finished/new models will have the workings too to prevent double posts.